When putting a custom PC together, securing your motherboard inside the case seems straightforward enough. However, leaving extra motherboard standoffs installed in the chassis is a surprisingly common mistake that can cause immediate boot failures or even permanently damage your components.
Standoffs are designed to keep the rear of the motherboard raised safely off the metal tray inside your case. If your chassis has a preinstalled standoff in a position your motherboard does not use, that brass pin can press directly against exposed solder joints or power traces on the back of the board, causing an instant short circuit the moment you press power.
Before dropping your motherboard into place, take ten seconds to align the mounting holes with the standoffs inside your case. Remove any unused standoffs completely to prevent shorting out your board and ensure a clean post check on your first power up. Have you ever had a build fail to turn on because of an extra standoff?
#Shorts #PCGaming #eTeknix #PCTroubleshooting #PCBuilding #TechSupport #PCMR #Hardware
Standoffs are designed to keep the rear of the motherboard raised safely off the metal tray inside your case. If your chassis has a preinstalled standoff in a position your motherboard does not use, that brass pin can press directly against exposed solder joints or power traces on the back of the board, causing an instant short circuit the moment you press power.
Before dropping your motherboard into place, take ten seconds to align the mounting holes with the standoffs inside your case. Remove any unused standoffs completely to prevent shorting out your board and ensure a clean post check on your first power up. Have you ever had a build fail to turn on because of an extra standoff?
#Shorts #PCGaming #eTeknix #PCTroubleshooting #PCBuilding #TechSupport #PCMR #Hardware
This website uses cookies
Comments 0
Be the first to comment!