Make your own inline filament diameter sensor (under $5)!

Let's take a closer look at the inline filament diameter sensor - available for DIY now!
Become smarter in 5 minutes by signing up for free today: http://cen.yt/mbthomassanladerer - Thanks to Morning Brew for sponsoring today’s video.

Download the design and all files (Fusion source files, Eagle PCB design, Firmware) https://www.prusaprinters.org/prints/57154-infiDANK
or https://www.youmagine.com/designs/infiDANK

Some of the parts required (full BOM at the links above)
SS495A linear hall effect sensor http://go.toms3d.org/SS495
ABEC-rated 623-ZZ bearings http://go.toms3d.org/623ABEC
6x2mm magnets on Amazon http://go.toms3d.org/6x2magnet
PTFE tube http://go.toms3d.org/bowden

Filament used:
Prusament PETG http://go.toms3d.org/Prusament

Product links are affiliate links - I may earn a commission on qualifying purchases (at no extra cost to you)

Previous video about the filament spool diameter measuring device: https://www.youtube.com/watch?v=-0D30mfIVd0

???? All my video gear https://toms3d.org/my-gear
I use Epidemic Sound, sign up for a 30-day free trial here http://share.epidemicsound.com/MadeWithLayers

???? Enjoying the videos? Support my work on Patreon! https://www.patreon.com/toms3dp